Used Claas Shaking System

102 available products

When a Lexion leaves grain in the windrow despite proper threshing settings, the shaking system is the likely culprit: a cracked shaker, a crankshaft bearing with play, and the straw is no longer aerated. TMC Bejenne dismantles Claas combine harvesters and offers their tested second-hand shaking system parts, ready to restore your machine before harvest.

Claas Lexion Combine Harvester: Shakers, Crankshafts, and Drive System

On a Lexion with shakers, the straw exits the threshing system and falls onto the shakers, mounted on two shaker crankshafts that oscillate them. Grain still trapped in the straw passes through the chests and reaches the cleaning system. Our Claas shaking system parts primarily come from Lexion 415, 420, 430, 440, 450, and 460, as well as Lexion 540 and 570. We also offer aerator crankshafts, drive gears and pulleys, and shaking system housings.

Dominator and Mega: Older Claas Models

  • Dominator 58 and Dominator 88
  • Dominator 96
  • Mega 218

For these older Claas models, a used shaker housing taken from a Dominator of the same generation is the simplest solution when the metal plate is pierced or the baffles are torn off.

Lexion 600 and 760: Rotor-Based Separation

Lexion models from the 600 and 700 series separate grain from straw with longitudinal rotors, without shakers. Therefore, parts classified under shaking systems for these models are not shakers. Before ordering, have our technicians verify the exact part name using your combine's serial number.

Before Replacing a Claas Shaker

  • Check bearing play on both crankshafts
  • Ensure that the shakers remain synchronized without end-of-travel impact
  • Identify any cracked plates near the fastenings
  • Note the number of shakers on the machine and its serial number

Claas Shaking System Parts at TMC Bejenne

All our parts come from combine harvesters dismantled on our 11-hectare site in Naintré, where TMC Bejenne has operated since 1945. Over 25,000 references are stocked here, and each part is checked in our workshop before shipment. A used original part retains the manufacturer's fixings and measurements without modifications. To compare with other brands, check out our shaker range across all brands.

Yes, if the replacement shaker has the same reference as its neighbors and the crankshafts are in good condition. A new or used shaker mounted on a warped crankshaft will wear out quickly: check the drive before ordering.

Five or six, depending on the machine's width. The number of shakers determines the crankshafts' length and the reference of the chests: note this before making a request. On a Claas with six shakers, a crankshaft from a five-shaker machine will not fit.

Provide the combine model, serial number, and if possible, a photo of the original part with its reference. Our technicians compare with dismantled machines. Request a quote at 05 86 24 00 26, or browse all the used Claas parts.